Pool Pump Setup for Circulation Pool pumps circulate water from the pool through the filter and back to the pool to remove debris and contaminants. The pool pump setup is usually located next to the filter in a concrete pit or recess below the water level of the pool so water flows by gravity into the pump.

Can you go in a pool with the filter on?

Many of the INTEX pump/filters are NOT UL rated and you should not swim with them plugged in. They do have one or two that are UL rated and can be left on while swimming. Just about all other pool equipment brands can be used while you are in the pool when properly installed.

Do you backwash or rinse a pool pump first?

Tip: Remember to “rinse the filter after backwashing to recompact the sand in the filter to ensure effective filtration.

How long should you backwash pool?

2 - 3 minutes After the hose fills with water, backwash your sand filter for 2 - 3 minutes, or until water runs clear. Shut off the pump motor and push the T-handle back down into locked position. Turn your pump back on and note the lower pressure.

How many hours a day should you run your pool pump?

That means that your pump is a good size and youll need to run your pool pump for about 5½ hours every day, lets call it 6 hours per day for good measure.

Can you backwash your pool too much?

Can You Backwash Too Much? If you backwash your pool too much i.e. time duration and/or close frequency then yes you can cause a lot of problems. Some problems that can arise from backwashing your sand pool filter too much are: Loss of water – 500+ litres of water can be lost in each backwashing cycle.